Aerospace Research Corporation
The Swallow   
Kirk Blackwelder 
(This Plane is Not an Easy One!)
STEP 1:  Take one sheet of 8.5" x 11" paper. 
STEP 2:  Cut piece to 8.5" x 8.5" square (save the remaining 8.5" x 2.5" piece). 
                Fold along lines as shown in figure 2.         
STEP 3:  Fold sheet in half along middle fold. 
STEP 4:  Tuck left side into folded half. 
STEP 5:  Repeat step 5 for right side.   
               This will leave a triangular shaped piece with 2 layers.  
STEP 6:   Fold the lower left and right corners of the top layer to meet the top corner. 
STEP 7:   Obtain remaining sheet of 8.5" x 2.5" paper.  
STEP 8:   Fold the sheet in half lengthwise. 
STEP 9:   Cut along lines as shown to form the tail section 
STEP 10:  Discard excess trimmings. 
STEP 11:  Unfold the tail section. 
STEP 12:  Insert the tail section into the lower layer of the triangular piece. 
STEP 13:  Cut triangular piece (with tail inserted) from tip approx. 3/4". 
STEP 14:  Fold the outer corners of the top layer in, to meet the midpoint of the centerline of  
                 the midpoint. 
STEP 15:  Tuck the split sections of the triangular piece into the inward folded top layer. 
STEP 16:  Fold airplane in half along centerline. 
STEP 17:  Grasp airplane along midpoint of centerline, holding the body with a "v" shape, 
                 and throw!